2010 nitro dodge front vent not blowing air 2010 nitro dodge air not blowing from front vents Blend air door inop, either from vacuum leak, bad check valve or bad actuator.
Question about 2007 Nitro SLT
Could it be an actuator or door not opening or broken? All vents have low volume of air coming out. I haven't tried or troubleshoot anything Have HVAC code checked--should tell you what is not working
Question about 2008 Nitro
...Could that even be possible? If core was blocked by leaves, etc, I suppose this might be possible, but more likely there is a flapper door not working correctly, due to vacuum leak or bad
Question about 2008 Nitro
...door actuator (4) Air inlet housing (5) Recirculation-air door (6) Blower motor (7) Blower motor resistor (8) Heater core (9) Air distribution housing (10) Blend-air door (11) Blend door actuator (12 ...
...door actuator and swap it out with a new one. Or another option is to swap it out with one of the other actuators. The blend door actuator is interchangeable with the actuators for the mode-air doors ...
dodge nitro heater blows cold on driver side heater door actuator bad. it is up under dash on the drivers side towards the center.
Question about 2010 Nitro
...actuator for the mode door in the heater housing. It shouldn't require replacement of the heater housing, but may require a lot of work to get to the heater housing (possibly removal) to replace the ...
2010 nitro. have plenty of heat, just wont change positions door actuator not turning
...door actuator. The blend door is responsible for directing air to the different vents, and if it's not functioning properly, it can cause issues with the airflow. Another possibility is that the ...
...is passing through the heater core. You probably have an actuator or blend door that is not working. It may be restricted by commanding it to work. A scanner could help you find out the
Usually answered in minutes!
262 Questions
49 Questions
37 Questions
36 Questions
42 Questions