...door won39;t stay closed there are various factors behind this:- http://www.appliance-repair-it.com/refrigerator-door-repair.html http://www.wikihow.com/Replace-a-Refrigerator-Door-Seal Two reasons ...
...Door won39;t stay shut. Normally when closed, you hear the seal take place, now it pops open Check the seal in the corners on the side of the door your hinges are on, ya may need to tack it down ...
amp; won39;t close properly You may need new hinges or the door is possibly out of the hinge socket. Try removing door and putting it back in place. These instructions should be in your users manual
Question about Designer Series DFUD140 (Ultra-Premium) Built-in Dishwasher
...door it won39;t start. For some time I would have to close the door a few times before it would run, so it may be the latch telling the washer, "hey, I39;m not really closed". What do ...
Question about Designer Series DFUD140 (Ultra-Premium) Built-in Dishwasher
...door won39;t close all the way but it39;s NOT the latch inside the door, the door seems to be lower than the latch. Sounds like your door hinges are worn. Pin and bushing kits are available at ...
* the hinge to the broil position. Put a nail or something so the hinge won39;t pop back in the door when you go to put it back. Once ya have it back in the stove, remove the nail and close the door
...door won39;t line up so i can close it i was reversing out of my garage and forgot to shut my car door,i've bent it forward and now i can't get it to shut until i can take it to get ...
Question about ABB1927DE Bottom Freezer Refrigerator
...amana Br22tw Bottom Freezer Refrigerator I switched the swing of the door and now door will not close all the way Check all the screws for the hinge and be sure the door is lining up
door won39;t close. When I open the front driver's door "all the way" something seems to catch when I try to close the door. Tonight, the door went out of alignment and won'
...hinge adjustment to move the door further across the opening giving the magnets a better area to hold on to . there is a slight amount of adjustment in the mounting points of the hinges. You may have ...
Usually answered in minutes!
3,171 Questions
1,894 Questions
1,239 Questions
1,098 Questions
927 Questions