...door on previa wont open or close properly Hi I have a 1993 previa van and the sliding door seems to have a problem it only opens slightly but when you push the rear of the door in it will open ...
Question about 24 in. SHY56A05 Stainless Steel Built-In Dishwasher
door wont close Door may have been pulled off its hinges, the d/w doors electric is connected at the bottom of the door and when it was pulled, there is the possibility that a short occurred. The door
Question about 24 in. SHY56A05 Stainless Steel Built-In Dishwasher
my fridge wont stop beeping Checked both door closed properly. If Door is closing properly then Door Switch will be defective.
...on the dryer does not close properly If door wont stay closed it may need a new latch it could be broken or bent.The door could also be bent or the machine not leting it close right.Hope this
...door wont close properly chef gbc5266wng the oven door wont close properly at the top, are the hinges able to be adjusted? Wow Must be a very old oven. The closes model number I can get is GBC26CK. ...
...door wont shut I wont shut properly it make like a clicking noise when it hits the catch but wont shut see this causes, and use the common sense. God bless youWhen your dishwasher door has a problem, ...
door wont close Roger, does lights blink when attempting to close door?? If so it is the photo sensing eyes. Be sure they are not blocked and properly lined.If all is ok, replace the photo ...
...door latch wont engage properly. The light wont go off as it should when the door is closed. If closed hard the oven will eventually work once in a while micro switch has loosened and moved back , or ...
Question about Garage Door 1/2 Hp
DOOR WONT CLOSE PROPERLY AND IT WONT LATCH.HINGES MAY BE STRAINED Hello friend, thank you for your post! It sounds like it could be an issue with the hinges. I would recommend having a technician come
Question about Garage Door 1/2 Hp
...wont shut the door properly? Why my electric doesn't close the door properly I have looked at everywhere where it might left little items cause stuck some where but none.. Need to look at rollers on ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions