Question about 3431126 SF 144-A CPC Drill/Driver
HAVE A HILTI CLUTCH DRILL MOTOR FOR CORE BIT SYSTEM CLUTCH SEEMS TO BE SLIPPING THIS IS SECOND DRILL MOTOR TO DO SAME PROBLEM AFTER OMLY ONE OR NOT EVEN ONE HOLE MABE THE TORQ OF THE DRILL IS NOT ...
parts where can i buy parts to this cordless drill? Hilti SF 121 A look at this website for parts.... ...
Question about Hammer Drill, 8.4 Lb 3 Mode, Te 16 C
...the manel and need to no how to use it... i dont have the manel and need to no how to use it The drill uses bits with the SDS+ connection end. You have three different modes of operation. Hammer ...
Question about TE 7-C 120V Rotary Hammer Drill
Hammer drill will drill but when set to hammer in drill or chipping mode it will not hammer any tips or solution are appreciated. thank You a.g. Make sure the bits that you put in there are SDS+ bits.
the drill is leaking oil As my knowledge drills not use oil just grease in the bearings.But if you need to service and the drill is not too old and the repair is not cost too much you can find parts ...
Question about TE 7-C 120V Rotary Hammer Drill
...the hammer cam, is it repairable? http://www.us.hilti.com/fstore/holus/techlib/docs/tool_schematics/drilling/TE_7_C.pdf Breakdown for the Double Insulated(2-wire) Drill ...
Question about Hammer Drill Bit TEYX 1 In x 21 In 340705
can i use any drill bit for drilling ...........in any drill machine or different drill machine have thier own drill bit the teyx bits are SDS Max which are common in the industry. Most hammer drill ...
will drill but no hammer n Make sure you have it in the hammer drill mode. To check that it will hammer you can remove the chuck and just run the drill with the front pressed against a wood surface. ...
Question about TE 7-C 120V Rotary Hammer Drill
What type of modern SDS drill bit fits a Hilti TE 72? sds is a standard adopted by all rotary hammer drill manufacturers It is the design of the slots and grooves in the end of the drill where it goes
Question about TE 7-C 120V Rotary Hammer Drill
i have a hilti dde 200 core drill and the tighting nut too sturdy drill is stripped it shakes a lot till i get hole started...what is the problem / how do i fix it It's a replaceble part correct? ...
Usually answered in minutes!
110 Questions
46 Questions
38 Questions
15 Questions
16 Questions