Questions & Answers for: Ford F-150 drive cycle

...drive cycle has not completed, it will only clear itself after driving the vehicle through certain driving conditions. If you try to clear the code, it will reappear until you repeat the drive cycle. ...

Drive cycle : Operating temp engine ( let it warm up ) At least 1/2 tank fuel A run of normal throttle usage, to maintain at least 46 mph for 5 min, back down to a stop and then back over 46 mph again

...cycles, to have the system fully test itself. Here is a quick URL that I could link to for a drive cycle ( mroe accurate than my typing skills this evening ). ...

...drive cycle what is the emissions reset drive cycle on a 1998 ford f150? You have to drive the vehicle after the codes have been reset to let the monitors do their tests....If every test ok it will ...

...Drive Cycle : http://www.obdii.com/drivecycleford.html If you just want to turn off the light, you can disconnect the battery for 10 min, and it will go out, but once you complete a drive cycle, if ...

...light is on) so it won't allow you to pass until it's good and ready. Take numerous short trips in your vehicle to hurry the process along, turning the engine on and off won't count as a drive

reset If you are asking about how long before the code would come up again after resetting, it is 2 drive cycles. Until that time, the DTC P1000 is set ( tests not completed ). Here is the write up on

drive cycle instructions need to reset computer on my truck so I need to learn how to do the drive cycle for this truck Your owner manual should have your info.

...drive cycle, see if it helps? There may be an idle relearn, if just idle issue? Usually it will relearn idle on its own by driving. Drive Cycle Recommendations: Most OBDII monitors will complete more ...

...Drive Cycle. The P1000 will be stored in continuous memory if any of the OBD monitors do not complete their full diagnostic check. Vehicle is new from the factory Battery or PCM had recently been ...