Question about Aquarius WD640 Front Load Washer/Dryer
...drum weights need tightening on my hotpoint wd64 washer/dryer as there is grey dust underneath.how do i check this. the machine motor is banging against the side when it starts its soin cycle Remove ...
...weight is attached to the top of the drum and can loosen and fall to the bottom damaging the spider pulley. If the counter weight is firmly attached to the top of the washer drum and the belt is ...
...weight is attached to the top of the drum and can loosen and fall to the bottom damaging the spider pulley. If the counter weight is firmly attached to the top of the washer drum and the belt is ...
...drum is in a sense sitting on a barring , it sounds like your barring is going out. Works with no weight, and if helping as you said. Normally means barring is worn out and can not handle any
...drum and with the weight of the wet clothes it will probably be worse than when dry. It is probably rubbing some where. Unhook the power and pull the back cover and look around carefully. Lift the ...
...drum bounces up and down like a weight on an elastic chances are the shock need replacing To check the spider firmly grasp the drum left and right and try to wobble it then turn the drum 1/4 turn and ...
Question about HE2 Plus Front Load Washer
and the larger the drum the more weight and I doubt they use larger bearings for more cubic feet machines. They need a buddy bearing or some sort of support to take all the weight off the rear bearing
Question about 1997 Caravan
...well it could be a bad rim or a drum such as throwing a weight off the drum. if you look at the drums there should be a spot where a balance weight used to be. if this is the case then replace
...drum will spin out of balance because the weight is trapped to one side. regualar use like this will break the drum bearings. Weighty things like towles & sheets have to be balanced around the ...
Question about 1997 Caravan
...weight of the drums and the pallet? 1 Layer = 12 drums
1 pallet = 3 layers
1 drum = 20 kg
1 pallet = 40 kg
3 layer w/pallet = (12 * 3 * 20) + 40
= 720 + 40
3 layer w/pallet = ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions