...out on the housing so you can slid it out. Good luck and take your time. Remove the air cleaner and duct assembly. Drain the coolant until the coolant level is below the thermostat. Remove the ...
I have no heat coming from the heater ducts, changed thermostat and flushed heater core, still only luke warm air. put in a higher degree thermostat
...out on the housing so you can slid it out. Good luck and take your time. Remove the air cleaner and duct assembly. Drain the coolant until the coolant level is below the thermostat. Remove the ...
...TO SIDE OF ENGINE.IT EXTENDS TO FLYWHEEL.ON THE 4 CYLINDER ENGINE YOU HAVE REMOVE THE AIR INTAKE DUCT AND RESONATOR TO REMOVE STARTER MOUNTING
...element unit that comes up as an assembly when you remove the back cap. I removed the air filter duct and sensor wire for ease of access. But you use a bar extension (like 10 ") connect to an ...
...(IAT) sensor electrical connector. Mass air flow (MAF) sensor electrical connector. Air inlet duct from the MAF sensor and throttle body. MAF sensor from the air cleaner housing. To Install: ...
will start when you step on gas peddle will not idle if you let of the gas SOUND LIKE VERY LEAN FUEL MIXTURE.INTAKE AIRLEAK AT THE AIR INTAKE DUCT OR STOPPED UP FUEL FILTER.
duct tape generally. I find that the least amount of light gets through duct tape as opposed to masking etc. Just apply as needed, but be careful not to cover up any important gauges. I know the alero
Where is the intake air temperature sensor on a 2000 oldsmoblie alero? In the intake air duct. A two pin connector, one wire is tan, the other is black.
...the glove box. The tube can be pulled from the heater core cover by hand. Detach the air intake duct from the bottom of the heater core cover. The air intake duct runs from the bottom of the
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
1,065 Questions
830 Questions
