scope out of elevation adjustment Have tried several different rails and rings If you are sure that the scope was mounted correctly to begin with, ie plenty of elevation left THEN you can install a ...
Question about Banner Dusk & Dawn 3.5-10x36 AO BDC .17 and .22 Riflescope (cat713510) Telescope
Elevation cap The elevation cap on my Bushnell Banner is broken. I would like to find a parts list. call [email protected] they can [email protected]
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
Cannot sight in riflescope for elevation, adjustment is maxed out Bushnell banner scope, Remington model 700. Shoots 6 inches high at 25 yards and elevation screw is maxed out. Try reversing the rings
Question about Sportsman 3-9 x 32 Rifle Scope w/ AO
...got Bushnell sportsman 3x9x40The problem is after I had try to Lesor bore sight for the 100 yd mark elevation adjustment deal sto at 1.50 " were it need to be at 2.00".Whats wrong , what can I do? ...
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
scope elevation adjusted allthe way up & still shoots low i have tc encore 30-06 pistol w/ tc mounts & scope, bore sighted & crosshairs low w/ elevation adjustment maxed out, windage is ...
Question about Banner 6-24x40 Mill Dot Reticle Riffle Scope, Matte Finish Rifle S
I HAVE LOST ONE OF THE CAPS OFF THE ELEVATION AJUSTMENT I HAVE LOST ONE OF THE CAPS OFF THE ELEVATION TURET ON MY BANNER SCOPE IT IS A TARGET SCOPE 6X24X40 WITH THE HIGH TORETS WERE CAN I GET A NEW ...
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
My elevation is not working, I am on at 25 ids but at 100 I am high about 12 inches. When I adjust my elevation it does not move , the bullet hits the same place. I have a bushel 3 by 9 . Help no time
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
My Bushnell Banner rifle scope 3x9x40 ia at max elevation and shoots low The scope is used on a marlin 1894c underlever rifle and attached to a weaver rail how can i fix this problem you might be able
...in the view, it is held in place with 1 screw. remove it and pull down towards the windage and elevation adjustment screws. There are 3 tiny phillips screws, remove them. Then unscrew the end of ...
Question about Sportsman 4x32 Riflescope (4x32 mm)
How to reset bushnell elevation adjustment to zero? Trying to set elevation adjustment to zero to start over. If you want to center the cross hair in the scope Rotate elevation down to it stops then ...
Usually answered in minutes!
80 Questions
59 Questions
43 Questions
41 Questions
89 Questions