I tried to install additional lighting in Corsa Utility but i think something fused coz now the light doesnt work at all. Any advice on the problem? you may have over loaded the light control unit. it
eml light, electronic light and oil light Just bought the 1.4 16v twinport corsa it drove home fine and next day will not start ticking under engine and eml light islashing in sync with it. The ...
opel corsa 2006 utility 1.7dti. The roof light, door bell and desh board light wont light check the fuses lower dash cover should have list or look in the owners manual
what is the red light for in 2001 corsa 1.6 hazard switch for asked local dealer they dont know When you push the light the lights on 4 corners of the car start flashing. In european countries you ...
Question about 2006 Corsa Utility
Opel corsa utillity 1.4i 2006 Battery light went on, thereafter EPS light went on just before loosing power steering. I then stoped and realised my idling was very high before all this my lights was ...
Question about 2008 Corsa 1.7
Cluster lights come on when ignition switch on . lightswitch off position . It has a sensor that turns on the lights according to how dark it is out side. The lights will come on even on cloudy days. ...
Question about 2008 Corsa 1.4
Chlaster lights come on when ign switch turned on .light switch off .replaced light swich the same . This car has a CAN-bus electronic system. Suggest you invest in a cheap OBD fault code reader from ...
Question about 2008 Corsa 1.4
eml on changed both sensors no change in idle and light on switch of restart run perfect for few seconds then rough idle again restart fine again for few seconds Id check to see if there are any other
Question about 2008 Corsa 1.4
2008 Corsa tdi1.7.Loose power when orange light come on for a km or so when light goes out power is back do this often on a long trip when power is gone only 100 Km/h What exactly does this light look
spanner light on opel corsa 1.4 2007model what cause that The engine malfunction light comes on to alert you to the problem. Then you connect a scan tool to the OBD2 port under the dash and the code ...
Usually answered in minutes!
57 Questions
54 Questions
29 Questions
23 Questions
22 Questions