end of the brass line adapter is the female end which has the double flare so you can then insert the steel line replacement with standard double flare into this end of the adapter. Steel line , bungy
line im replacing my rear end on my 00 f-150 and my new rear end has a cut brake supply line and the line is compression fit to the rear end how do i take compresion line off Flex line screws into the
line is small on one end and bigger on the other or two lines are two ldifferent sizs Not sure I understand your question, but I'll try to help, the brake lines are one size (the diameter of the line)
Question about Poulan/Weed Eater #Wt200 711724 24cc Gas Blower/Vac
...end of the line and cut a taper on the end. Thread the end through the tank, into the outlet hole and aissist it so your filter sticks through the tank hole. There was a ring on the outside of the ...
line and slide into the large end.push the two parts of the line together and work the tool into place.after the tool is in place pull the lines apart.if it does not seperate clean the large end which
Question about 1997 Ram 2500 Club Cab
...line on the rear end is actually a vent line, not a vacuum line. The bolt that secures the brake block usually is hollow and has a barb on the end that the hose goes on. Sometimes the bolt/barb rusts ...
...line is only held on by clamps at both ends or one end at the rack assembly,even though the fitting it connects to may have a nut fitting that threads into the rack.the pressure line always has ...
...end of the line through each hole and then pull on both ends until the bend of the center of the line won't allow any more slack. If your trimmer has the place to hook the bend, hook there and start ...
Question about 25cc Gas Line Trimmer
McCulloch Pro-Mac 1 Super line trimmer how to remove drive cable at line spool end of trimmer How do you remove the line drive cable at the line spool end of the trimmer Comes out the other end
Question about 25cc Gas Line Trimmer
...end of the line and carefully drain any fuel into a sealable container. In the same manner, detach the fuel line from the tank end. You may now wrap it in a cloth and take it to match up with a new ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions