Questions & Answers for: Briggs & Stratton engine diagram petrol

...diagram to show valve timing with crank shaft for a briggs and stratton 3 hp petrol engine "3 HP" means nothing. For definitive, need the Model, Type and Code numbers off the engine. But probably 90% ...

...engine but it will not run or start for very long. The only way to start it is by putting some petrol in to the carburettor & then it has high revs. I believe that the linkage is not fitted ...

the engine works with no problem but the tines dont turnits a briggs and stratton rotavator and has full oil and petrol usually belt driven check the belt

petrol and how much 4stroke oil to add for my classic 3.5hp briggs and startton. Your engine is a 4 cycle engine, if memory serves. You should not be mixing oil with the fuel. The crank case will hold

...petrol mower. (Briggs & Stratton engine) It has had little use for about a year then stored unused in a dry shed for 10years and will not start. I accept that I need a new battery but it wont ...

Stops running after the initial primer of petrol, runs for a few seconds then stops, if pumped again it works again You need a new carb. diaphagm.

...petrol). it runs fine BUT when I stop - it will not restart. It usually takes about 30 minutes before the engine will start again. Any idea where I might be going wrong ? The tempature might be ...

...petrol mower that starts first pull but seems to be searching for revs when running , don't know if I have some how set the two springs up wrong (the ones at side of carb) as I have no diagram Hi ...

98902-2065-B1 briggs & stratton oil:petrol ratio pls This is a 4 stroke engine which requires an sae 30 weight oil in the crankcase and straight gasoline (petrol) in the fuel tank

Petrol/Oil in air box filter 140cc Briggs and stratton engine has foam filter in air box that has turned black (petrol/oil??) which has made the filter filthy dirty. Would that be oil getting past the