Questions & Answers for: engine lock

1993 lumina engine locked up my mom was driving my 1993 chevy lumina 3.1 euro 2d for awhile and apparently didn't put any oil in it. I had 2 different mechanics tell me the engine locked up and there ...

...engine lock up? Overfilling will not lock-up the engine. There is probably another cause for the engine to be locked-up. A starter can be locked against the flywheel. The engine oil can be ...

engine as locked how do i unlock it when i take pull start cord off. engine is still locked it was working oka then just stoped and locked its self If the pull will not move it and with it off still ...

will a compression test will let me know if my engine is locked or seized If you believe the engine is locked you should put a wrench or socket on the crankshaft bolt and see if you can turn it (turn ...

...? The serpentine belt could lock up the engine if one of the pulleys was froze. Sometimes the alternator or power steering pump will lock up. But if the belt is off the engine it would have no

...engine and strip it down as not all locked engines are un- repairable ( depending on the reasons for the lock up). Next best bet is to get a good unit from a reputable wrecker or a reconditioned ...

...lock-up is controlled by the ECM based on engine rpm, engine load, engine temperature, vehicle speed, transmission temperature, and shift range selection. The ECM determines the lock-up status of the ...

lock the crankshaft by removing the engine speed sensor and inserting the tool . rotate the engine by hand until it locks into place . the 2 camshafts are locked by removing the two plates on the side

...lock up and keep the engine from turning. Both can be checked. Remove spark-plugs and check for coolant. After the car was last used the pressure in the coolant system could have allowed the coolant ...

...engine is locking up. It doesn't lock up til I snug the bearings down Did you maintain the clearance between the crank bearings and the crankshaft? Same goes for the rod bearings. Is the oil pressure ...