My KTM 250 EXC has been sitting all winter. Now it won't start. Plug looks fine and I put fresh fuel in. ???? check oil and try to choke with hand and clean carb
engine push oil. White smoke and oil leaking from the tailpipe. Any ideas? g'day Murray! Could actually be a couple of things.I'll try to eliminate them by degree of difficulty and cost. first up make
leaking oil out the clutch cable recess on the leaking oil out the clutch cable recess on the side casing KTM are leakers- Pull side case and grommet the in side
oil leak from my ktm 250exc from behind front drive sprocket Replace the output sahft seal
...oil first though. if not which i think is most probable the engine will need splitting if you are good with spanners it is quite easy being a 2 stroke .in brief remove engine remove bore and carb in ...
oil some out of any place it can on the right side. If this is the case, the engine will have to be pulled and completely disassembled to replace your crank seals and possibly the main crank bearings.
...engine oil (e. g. Motorex Top Speed 4T 15W50), replace plug and check engine for leaks. TRANSMISSION AND CLUTCH WILL BE SUBJECT TO EXCESSIVE WEAR AND TEAR, IF YOU USE TOO LITTLE OR LOW GRADE OIL. USE ...
1998 KTM 250 exc. Loosened oil level bolt and wont retighten. Also gray metallic oil oused out. What type and how much oil would you recomend? Chances are that the prior owner pretty well stripped the
Anti freeze in transmition Thank you for contacting FixYa with your inquiry. This is usually a sign that the inside O-Ring seal of your water pump is is bad and allowing coolant to pass into your ...
Question about 2005 EXC 250
How do I replace the output shaft oil seal on my KTM 250 SX 2014? http://youtu.be/pefRYiaHKqA check this out
Usually answered in minutes!
16 Questions
6 Questions
4 Questions
3 Questions
1 Questions