cuenta revoluciones mi auto dejo de indicar las revoluciones, donde debo verificar o revisar este problema que al parecer es electrico de antemao gracias Hola amigo, a mi me paso lo mismo y creo que a
ginko no me pasan los gases en alta y bajas hc a 2500rpm y co2 a800rpm es catalitico Sorry, can't help, do not speak the language?
1000. los puntos de abajo del asiento trasero ya los coloque dado que encontre donde iban. mi duda es el punto de arriba sobre los costados donde va. me llamo gabriel heide y te escribo desde Uruguay.
...now it won't start. It seems to have weak spark and maybe a fuel issue. i have by passed the ballest resitor to little or no differance, and when i tryed a couple of spare coils i have (msd
Question about 1990 Charade
...plugs are replaced or any distributor maintenance is performed. Ignition timing at 1000 RPM or less should be as follows: on 1989 1.3L/4-79 engines, 3-7°BTDC; on 1990-92 1.3L/4-79 engines, ...
...use the 600 grit paper with water and rub the plastic lens until its no longer yellowish.(takes a little while) then after switch to the 800 grit, same thing-wet and in circles...repeat with ...
...put in 2L initially, then run the engine for a few moments then switch off. After a few minutes recheck cleaned dipstick level and top up as
cual es el orden de encendido porfas ayudaa!! 1342
what should the ignition timing be set at 3 cylinder 5 degrees at 750-850 RPM ( with terminal "T" at six pin connector connected to ground ) 4 cylinder 3-7 degrees at under 1000 RPM ( must have vacuum
Usually answered in minutes!
333 Questions
102 Questions
93 Questions
14 Questions
2 Questions