Questions & Answers for: Kenmore HE2 f4 code flashing

Question about HE2 Plus Front Load Washer

1 Answer

It does not work. It flashes F 22 It does not work. It flashes F 22 Thats a door lock failure code. You can try unplugging the washer. Then plug back in and shut the door firmly before trying to ...

Ad

Question about HE2 Plus Front Load Washer

1 Answer

code F 24 what does it mean The washer dose not allow me to do anything when I push start. All the areas light up and flash with code F 24 The F24 error code indicates a problem with the water ...

Ad

Question about HE2 Plus Front Load Washer

1 Answer

Codes SD and F1 When I tried to wash a load of cloths ealier it stopped, and flashes a code f-1 and all the other light blink (express wash, normal, rinse/spin, etc.) My wife said it flashed a SD code

Question about HE2 Plus Front Load Washer

1 Answer

code keeps flashing which water supply trouble but there is plenty of water Hi Thanks for using FixYa. Error code F/H means no water was detected entering machine or Pressure switch trip not detected.

Question about HE2 Plus Front Load Washer

1 Answer

...flashing H... F mean? Code "FH". If after 30 seconds the control does not detect water entering machine, the valves will be turned off and the error code will be displayed. OR If the control has ...

Question about HE2t 3.7 cu. ft. Front Load Washer

1 Answer

...code flashing so I don't know where to start looking for the problem. I have cleaned the filter near the pump and it didn't have much in it. This should take 30 minutes: Remove the panel that ...

Question about HE2 Plus Front Load Washer

1 Answer

washer will not run performed diagnostic test by pressing button 4 seconds on/off. Lights flash but no error codes are displayed. door remains locked at all times(used manual release). After lights ...

e1... what do these mean? I have the manual for the Kenwood HE3t. It says nothing about e1, but for F4 thru F16 it says to press PAUSE/CANCEL twice to cancel the cycle then start again. If the problem

Question about HE2 Plus Front Load Washer

1 Answer

...F4 to F16] (Electrical problem) Select PAUSE/CANCEL twice to cancel the cycle. Select DRAIN/SPIN if there is excessive water in the washer. Re-select cycle and press START. If the problem remains, ...

Why are there no error codes when running diagnostic test? Replaced broken water pump. I followed the manual to run diagnostic test. All lights flash, etc., then all blank except "clean clothes" light

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...