Questions & Answers for: finished spin wash bosch light

spin. The wash cycle (regular cotton, cold or warm) proceeds as far as rinse/spin then stops cold, and the finish light flashes. Have tried re-setting the selector to Off for 2 minutes then setting it

...finished,however when i put the machine to just spin the job was completed.I also noticed that the active light flashing.About ten minutes into wash cycle machine stops and you have to press button ...

...Spin / Finished lights started flashing and the bell sounded. I can't open the washer, and can't start a new cycle (the Start / Pause) button isn't active. I called Bosch and they had no idea what to ...

...wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was ...

...finished it drains then rotates clothing back and forth for about 5 mins then stops and active light flashes, softner is still in centre compartment. No power was put to solenoid Y2 or Y3 (y2 main ...

...spin, wash and finished lights simultaneously, but won't proceed with any cycle chosen. I had started a new load and the machine stated as normal (filling with water and drum rotating), but then I ...

Finished, wash and spin lights flashing. Door Finished, wash and spin lights flashing. Door locked and cannot get clothes out I just had this problem! To get the clothes out, open door manually ...

...spin, wash and finish indicator lights flash simultaneously when try to start. Make sure dial is switched to 'off'. Unplug your machine, then plug it back in. Hold down the rinse and delay buttons ...

Finished/Spin and Wash Lights are all flashing alone with a beeping tone. This is in ALL wash modes except off. my machine did that when stuck on spin cycie all i did was unpluged it for a few seconds

My Classixx 1000 machine 'end' light is flashing and the door will no open after finishing the wash -any advice pleas? I have tried selecting drain and spin modes with no success. change the door lock