...chain popped off and I can't get it to fit back on. Losen the bar mounting nut, then losen the chain tension adjustment screw until the chain can be reinstalled, then tighten the tension screw until ...
...fit the chain back onto the bar -- be careful to align the drive teeth on the chain into the slots on the drive clutch. When the chain is back in place, turn the tensioning screw clockwise to tighten ...
chain is a snug fit in the bar rails, with a gloved hand pull the chain around the bar manually to make sure it turns freely and is fitting into the sprocket correctly, re adjust the chain if required
...and readjust the chain tension.... You may have to loosen the tension-er to get the new chain to fit on properly... they normally are a bit smaller then an older chain that has stretched... ...
chain fit correctly on the drive sprocket and that the chain is in the groove on the bar. Tighten the bar nuts finger-tight. Tension the chain by turning the chain tensioning screw clockwise using the
...the chain tension screw and turn it to release tension on the chain. The screw drives the pin that fits into the hole on the bar. When you replace the chain, line up the pin and the hole, and ensure ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...Fit the chain on the bar.(ensure that the chain travels in collation with the sprocket at the end of the bar if equipped). When looking at the saw from the sprocket side(bar to the right) the ...
Question about E200/300 Electric Scooter Battery
...the tensioner keeps hitting the gears and makes the chain came off again. tensioner should fit on axle or behind the axle on the edge of thew fork where hardware should be mounted to adjust ...
Question about E200/300 Electric Scooter Battery
...chain tensioner fitted has been garaged for a month turns over but spark wont ignite when turning had a sparklike misfire if worked fine before cam tensioner fitted, i wonder if cam chain slipped a ...
...the gears I am unsure what step to take Does it not fit the gears, or is it too loose when installed ? Does the new chain fit the old gears ? Is there a tensioner or guide not installed correctly
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions