Question about Propane Forced Air Heater w/Electronic Ignition (50,000-80,000 BTU)
coleman evcon dgat090bdd. New ignitor won't heat up. It has a new ignitor and circuit board and it still wont heat up. I get 4 flashes from the board. Looks like 4 flashes might be high limit fault on
Question about Propane Forced Air Heater w/Electronic Ignition (50,000-80,000 BTU)
coleman 90% gas furnace control board stolen replaced board- furnace will lite ,just when the blower fan is about to start burners go out.Checked high limit-ok,checked flame sensor-ok(bypass w/jumpers
Question about Propane Forced Air Heater w/Electronic Ignition (50,000-80,000 BTU)
evcon coleman furnace I have a Evcon mod.# DGAH077BBSB with 4 light flash code
Question about Powermate Powermate 5000W Generator
...flashing the field, by using a 12V car battery, unplugging spark plug, hooking + of car battery to small terminal of generator outlet, and - of car battery to large terminal of generator outlet. I ...
Question about Hot Water On Demand
pump works ok fire starts on for 2 seconds then goes out pump works ok fire starts then goes out straight away the green dignostic behind front panel flashes twice intermittently until unit is ...
armstrong upflow,unit works intermittent problem,call for heat nothing happens,error code of 5 blinks then 6 blinks. i have no manuel, and the panels dont have the codes on them. anyone have access to
My furnace Coleman DGAT070BDD light flashes 4 times. Do you have any idea what causes that? Trying to find out what 4 flashes on the internet will be exhausting. However if you have the manual it is ...
I have a Coleman Evcon Mdl DGAT070BDD I am getting a trouble code 4 Flashes, which means Limit is Cycling. I replace both the control board and the limit switch, and still have the same problem. Your ...
...Flashing code of three (red light) flashes (Combustion air switch failed to close) fault code. Replaced and/or Serviced the Following Items: 1) Air Contact Switch. ($45.00) 2) Air Filter ...
Question about Hot Water On Demand
Gas furnace call for heat, Blower comes on immediately, no heat green light 2 sec, 3 flashes one time, 4 flashes repeadly after that, no igniter, no heat, Might be the pressure switch. If it gets ...
Usually answered in minutes!
302 Questions
212 Questions
61 Questions
27 Questions
20 Questions