Position the crankshaft harmonic balancer on the crankshaft. Hold the flywheel with a (J 37096) flywheel holding tool. Using a (J 36660-A) torque/angle meter, tighten the harmonic balancer bolt to 110
...position. It should be located near the flywheel and have a small magnet attached to it. Ensure that the sensor is aligned with the magnet and that the wiring is connected securely. If the sensor ...
flywheel. The crankshaft position sensor is located next to the flywheel/torque converter. The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator
...Position sensor wire shield to sensor. Push sensor against flywheel/drive plate. With sensor pushed against flywheel/drive plate, tighten mounting bolt to 7 Nm (60 inch lbs.) torque. Route sensor ...
Question about 1994 New Yorker
...flywheel,if the flywheel is cracked and lost its position then it does exactly what you describe . You either have a cracked flywheel or a jumped timing belt.The exhaust can be plugged ...
...position sensor is hitting flywheel flywheel got damaged somehow can I bend it down with out a problem or is a new one a must need What type of car is this..but to answer your question the flywheel ...
...flywheel have offset bolts so can only be fitted in the correct position. The best way to set tdc is with a special tool that goes into the side of the block at g28 sensors hole, or to set tdc with a ...
Question about 2002 Passat
...position on the flywheel after it has been removed.? I have replaced clutch and flywheel on this motor and now it won't start, there is a tin plate bolted to the flywheel ( I'm guessing this is to do ...
...flywheel/driveplate and provides the ECM with crankshaft position and engine speed. The sensor is a Hall effect type that senses the passing of teeth on a flywheel/driveplate, because the teeth ...
Question about 2002 Passat
...flywheel housing. There are geographical variations and a couple of engines fitted to the Jimny and not all engines are fitted with a crank sensor. The front position is favourite if your engine has ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions