edge of the door opening. A 1997 Ford Explorer would have a switch similar to the image below. It is highly probable that the switch has some corrosion causing it to engage every now and then. Another
door ajar warning light and message will not go off even when the door is shut and car is in drive. Also the keypad isn't working properly unless this vehicle has over 36,000 miles on it, I would take
...edge of the "A" pillar. inside the door jam there should be one or two buttons. NOTE: IF THERE ARE TWO BUTTONS ONE OF THEM MAY BE FOR THE PURPOSE OF ILLUMINATING THE DOOR AJAR DASHBOARD LAMP. Look at ...
door ajar light stays on check for a shorted switch at each door, its the little black button along the door edge,,
...ford edge? As specified above it is inside the door attached to the "Door Module". You have to take off the plastic panel with trim facing the inside first. Then you see the door module. You have to ...
ford edge 2013 door ajar sensor I located the switch and cleaned up underneath it as well as a shot of WD40. 1st open the door. 2nd manually close the latch with a screw driver. Look for the white tab
...ford edge I have open and shut the door about 8 times. I thought maybe because it is about 5 degrees here today that it might be just cold open the door and manually press in the little switch that ...
Question about 2012 Edge SE 4dr SUV 3.5L V6 6-speed Automatic
...ajar relay on 2012 Ford Edge Figured that slamming door will sometimes turn false alarm off check the adjustment on the door switch it is the same one for the interior lights . or the switch is
Question about 2012 Edge SE 4dr SUV 3.5L V6 6-speed Automatic
...Ford Edge door ajar warning light and message will not go off even when the door is shut and car is in drive. Very common Ford problem. The issue is a stuck door switch plunger located at the bottom ...
Question about 2012 Edge SE 4dr SUV 3.5L V6 6-speed Automatic
...Ford Ranger Edge 3.0L V6 Dome light does not work replaced all switches and Dimmer Switch. Check all wiring and no shorts to ground. Bulb is good and works when I apply power directly. Just need to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions