Questions & Answers for: ford ranger oil pressure sending

ranger on cold mornings the oil pressure gauge shows zero for about 5 to 10 minutes. I want to replace the sending unit but can't find it. Pictures would help. THE SENDING UNIT WILL BE LOCATED DOWN BY

oil pressure problem well our 2000 Ranger 4x4 overheated yesterday..we changed the thermostat. After that the oil pressure started fluctuating..we changed the oil and the oil filter. Now the oil ...

...ford Ranger I have a loud knocking noise from the lower engine until it warms up. When I drive to work 15 miles on the highway the oil pressure gauge is fine. When I exit the highway and stop the ...

where is the oil pressure sending unit on a 1988 ford ranger 2.3 liter? Left rear of cylinder head, by where it bolts to tranny.

low oil pressure on guage of my 89 ford ranger 6 cylinder Could be low oil level, a bad sending unit, or actually low oil pressure due to a worn oil pump or worn bearings.

...ford ranger with a 2.9 L engine 2.9L and 4.0L engines-Left side front of the engine, below the cylinder head in the engine block. looking for the oil pressure sending unit in a 1987 ford ranger 2.9 ...

where is the oil sending unit on a 1992 ford ranger 3.0 v6 moter The Oil Pressure Switch is on top of the engine, in the following location:

...ford Ranger? oil gauge vibrates loudly after driving freeway speeds (65+ mph). any help? Factory gauges (especially Fords) are not known for being terribly accurate or reliable. As long as the gauge ...

What would cause the oil pressure to go up and down on a1990 ford ranger Low oil. Bad or loose sump in pan. Bad sending unit or gauge in dash(not likely the gauge).Bad or clogged oil filter. don-ohio

...Ford Ranger truck 4 cyclinder 5 speed 2.3 Engine please... My info says it is in cylinder head #21. Most oil pressure sending unit switches are about the size of your thumb, and are screwed into the ...