...Freelander, along with all Land Rovers are permanently in 4 wheel drive: You need to take the car to a workshop to see what is happening. Freelanders have big problems with the transfer box, this ...
i have a nocking noise from front of my freelander the noise started when i reversed with left full lock on but now i get it even when going straight forwards it sounds like a train chug chug chug hi,
Freelander 1.8 started reversed off the drive, cut out and now wont start. check for timing belt failure by removing black plastic engine cover on side. if ok and tight check crankshaft sensor these ...
Question about 2002 Freelander
...on a freelander 1 The reverse light switch on a PG1 gearbox is screwed into the bottom of the gearbox casing, On a Getrag 282 gearbox its screwed into the top of the gearbox casing, Hope this
Question about Transmission & Drivetrain for Land Rover Freelander
freelander 2002 transmition won't go in reverse what can i do it won't go in reverse Check the fluid. Is the engine light on??? Yes? Diagnose.... No.......... it's broke
Question about Emission System for Land Rover Freelander
reverse gear not working on landrover freelander 2006,but if you put th D to drive the car move only when you put the reverse dont want to go way ?thank run fault codes and look for faulty reverse ...
Question about Emission System for Land Rover Freelander
freelander trouble wit reverse i just replaced the engine in my 2003 landrover freelander it was started by original owner and i finished the job there are 2 vaccuum lines ( the kickdown line and line
...freeLander Open bonnet. On top of engine towards the front, is a head cover. Remove that. Remove with caution the HT cables. Get a long socket wrench for plugs and remove each one. Careful with grit ...
Question about 2002 Freelander
My 2002 automatic Land Rover Freelander starts just fine, idles fine, reverses fine -- when you shift into drive the RPM go way up, but the car won't move... it will only move in a very low gear. The ...
reverse Freelander v6 was under service for the rear camshaft seal. After service, the TC alarm stayed on from the dashboard and speed changes was not smooth and reverse power too low. Replaced AT oil
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions