Questions & Answers for: Frigidaire front door

...I have a front load frigidaire washer and I can't find the lint filter THERE SHOULD BE A TRAP DOOR EITHER RIGHT INSIDE THE FRONT DOOR OR ON THE TOP OF THE UNIT MORE LIKELY RIGHT INSIDE THE FRONT ...

...Front Loading Washer Error Codes Whirlpool Duet Washer Door Latch Stuck in Lock Position; Washer Repair Replacing the Door Latch Assembly in a Kenmore / Frigidaire Front Loading Washing ...

...door switch to the front panel. Peel off the door gasket near the door switch then pull the door switch off the front panel and out of the washer. Disconnect the wires from the door switch terminals ...

front panel then pull the door lock and switch assembly out. Transfer the wires to the new door lock and switch assembly then install into place. Put the door gasket back and secure it with the spring

front panel. Take the door lock/switch assembly out of the front panel then disconnect the door switch harness then short circuit the terminals by putting a jumper wire between them. Put the door lock

...front door will not lock and pau is flashing on my frigidaire affinity front end loading washing machine and it will not start You will need to replace your door lock mech.On the bottom of the door ...

FRONT DOOR AFTER REMOVING FRONT PANEL cannot close door Please check if the front panel was replaced into the correct slot. It is possible that the alignment was shifted and so the door hinges are out

...door latch ? the strike broke off in it You shouldn't have to take the front door or panel off to fix the door latch. You should have part on the door and part on the inside panel of the

...front door Good Morning Donna, I am happy to assist you! Often when a washer is leaking through the front of the door is due either to a damage tub or a poor door sealed. Therefore, as the tub spins, ...

front door of front loader washing machine Hello Friend, that's a great question! In order to provide you the correct location of the door switch on your Frigidaire front load washer, I will need your