...sprocket onto the camshaft and then tighten to 77 ft. lbs. (105 Nm). Lubricate the timing chain with clean engine oil. Tighten the tensioner retaining bolts to 17 ft. lbs. (23 Nm). Remove the tool ...
...sprocket with the mark on the crank. if your facing the motor front, the keyway will be on your right, with the hole another 90 degrees around. I recommend using a ruler to create a line from the ...
sprocket, chain link, front face of cylinder and crank sprocket for reference. Retract the timing chain tensioner shoe by using J?33875 or equivalent, on both sides of the tensioner and pulling on the
sprocket and the timing chain at the same time . . . Fig. 5: . . . then remove the tensioner assembly Fig. 6: Compress the tensioner spring and insert a cotter pin or nail in the hole provided to hold
...front of engine/normal rotation, until the camshaft sprocket timing dowel pin holes line up with the holes in the timing chain housing. The crankshaft sprocket keyway should point upwards and line up ...
Question about Mr Gasket Timing Cover Chevrolet El Camino Elcamino 75
sprocket and the timing chain at the same time . . . Fig. 5: . . . then remove the tensioner assembly Fig. 6: Compress the tensioner spring and insert a cotter pin or nail in the hole provided to hold
Question about Mr Gasket Timing Cover Chevrolet El Camino Elcamino 75
sprocket and the timing chain at the same time . . . Fig. 5: . . . then remove the tensioner assembly Fig. 6: Compress the tensioner spring and insert a cotter pin or nail in the hole provided to hold
...sprocket Disconnect the negative battery cable. Remove the timing chain front cover assembly, as outlined earlier in this section. Rotate the crankshaft until the timing marks on the crankshaft ...
...sprocket seats in the notch in the front of the intake camshaft. Turn the crankshaft 45 degrees in either direction. Turn the intake camshaft to the appropriate location. Turn the crankshaft back to ...
Question about 2001 Cavalier
...front cover and gaskets. 5. Rotate crankshaft in clockwise direction until camshaft sprocket timing dowel pin holes line up with timing chain housing holes, Fig. 1. 6. Remove timing chain guides. 7. ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions