...front, never backwards). Make sure the marks still line up, loosen the tensioner, allow it to retension itself, and tighten the tensioner bolt. If the oil pump sprocket is not timed correctly, the ...
sprocket (6306) aligned with notch in engine front cover (6019) . Align triangle on camshaft sprocket with triangle on inner timing belt cover. Align diamond on oil pump sprocket with diamond on inner
...Front Cover in this section.Remove the crankshaft sensor ring from the crankshaft.Rotate the crankshaft until the timing mark on the RH camshaft sprocket is approximately at the 11 o'clock position ...
...sprocket bolts in the correct sequence using 2 steps, as follows: Step 1-30 ft-lbs (40 Nm) Step 2-tighten an additional 90 degrees Position the crankshaft keyway in the 11 o'clock position. Lubricate ...
...sprocket that is in turn connected front & back to the 2 camshafts. Thus a 360o turn of the crank will turn both the camshafts 180o. Firing order is 1-4 2-5 3-6, Right side numbers 1,2,3. Left ...
...sprocket mark to the front cover notch. Align the oil pump sprocket diamond to the engine front cover diamond. Align the camshaft sprocket triangle to the engine front cover triangle. Here are the ...
...sprocket and chain assembly Left front cassette retaining bolt Cassette chain and tensioner assembly Rear jackshaft plug from the engine Right rear cassette retaining bolt and spacer Right rear ...
...sprocket timing mark alignment-4.6L engine Apply sealant to the front cover mating surface as shown. Fig. Sealant application to the front cover mating surface-4.6L engine Install a new gasket on the ...
sprocket (6306) aligned with notch in engine front cover (6019) . Align triangle on camshaft sprocket with triangle on inner timing belt cover. Align diamond on oil pump sprocket with diamond on inner
Question about 2005 Ranger
front crankshaft seal? You have to take the timing chain cove to access the sprocket. Use a 3 finger puller to get the sprocket off the crank. Changing the crank seal is way easier if the cover is off
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,347 Questions
2,636 Questions