sprocket I have theS-25 but the sprocket wobbles I think it needs new bearings. I took the nut off the left side of the sprocket but, i cannot pull it off. Do you need a special tool to pull it off? ...
Question about Pacific Evolution Women's 26 Front-Suspension Mountain Bike
raising the handlebars You will need a 6mm allen key to loosen ( turn anti clock wise) the handlebar stem bolt which when you sit on the bike and look down its just under yer nose :) Please make sure ...
my chain keeps locking up or slipping, i just put a new rim on, i tryed to fix it but now use, how will i fix it? check to see if all chain rollers between the links are there.if one is missing then ...
...so the upper pulley exactly matches the teeth of the small cog. Run the chain a bit with the front derailleur in the large ring, adjusting the limit screw until the pulley and the cog seem to ...
Question about Schwinn Protocol 2.0 26-Inch Dual-Suspension Mountain Bike
i loosend the front wheel berings on a quick release wheel but know when I try to tighten it, it gets to tight and doesn't spin right ...
Brakes are not working that well. How do you adjust the brakes, especially the front brakes. http://www.bikewebsite.com/bicycle-bra.htm This should help you.
...front sprocket to the top of the rear sprockets, between the rear sprocket and the top derailleur wheel and then between the upper and lower derailleur wheels. It then goes forward toward the front ...
Question about Pacific Evolution Men's Mountain Bike 26" 18 Speed
...you LIKE the handlebars, the stem is the best and least-invasive option as most new ones come with front loaders (detachable front caps) that allow replacement without stripping components off one ...
Handlebars not straight with front wheel There is a long bolt (of which you can only see the head) in the center of the handlebar stem. The nut (which you can't see at all) at the ...
Question about Pacific Evolution Men's Mountain Bike 26" 18 Speed
one final is the bike just may not go into 6th gear depending on which gear you have the front sprocket in because it would pull the front sprocket to far past the crank space where the pedals are at
Usually answered in minutes!