Questions & Answers for: Pontiac G5 front tire move back 2

Tire want's $40 to replace the light. pg 5-43 in your drivers manual tells you how. You just need to remove the 2 hex bolts on top, then grab the whole assembly and pull it at an angle up, and towards

...tire, now my front tires are reading that they are the rear tires and my rear tires are reading as my front tires. Is this suppose to happen? Also when my daughter, who is 8 months pregnant sits in ...

front. but after initial start no tightness or feeling or something loose just every once in awhile vibration. Tire is not wearing unevenly. Normally when you get tightening at the steering wheel that

...back under front of car and reach up and turn out(about 1/2 turn) the bulb socket from the light assembly. After you replace the defective bulb it goes back in the same way it came out. Good luck, ...

...tire, i checked the tires and there's nothing stuck in them, any ideas what it could be? If the noise is coming from the front it could be a wheel bearing. If you change lanes and the noise stops ...

cannot start car unless you move the tires cannot start car unless you move the front tires or jiggle the steering wheel. Now it is locked up and car will not start Bizarre, see the dealer on this one

...tire pressure. I have raised the car and checked for bad hub bearings and tie rods with no fault. I even bought a torque wrench and adjusted all of my lug nuts to the specified torque. If it is the ...

tire monitor my service tire monitor light keeps coming on. i checked the pressure and had the tires rotated. and now my temperature gauge isn't working When you have tires rotated, you have to go to ...

...front tire Very often the cause of coolant being expelled from the reservoir is due to a faulty head gasket leaking compression air into the water jackets. When the engine stops circulating the ...

...Move the plug from cylinder 2 and put it in cylinder 4. Run the car. Is the misfire still on 2 or has it moved to 4. Yes? the plug is faulty. No? Next test. Clear the code Move the coil pack from ...