Questions & Answers for: McCulloch fuel cap

...fuel tank becomes pressurised. Any ideas please Yes, I think the gas cap may be clogged. The gas cap must be able to breath, otherwise this vacuum will occur. Try starting your trimmer and when it ...

...fuel cap is clogged. The fuel cap must be able to breathe in order for the carburetor to operate properly. One way to be sure that it is the fuel cap is: The next time the chainsaw starts to die, ...

...fuel cap. Sounds like a vapor lock in the tank from an unvented cap or a blocked cap. If it runs with the cap off or loose, replace the cap. DId you check the fuel filter?. If you can reach down ...

...fuel cap for any vent holes being plugged or rubber components that are distorted. 2) Check fuel shut off valve for being plugged with debris or rust. 3) Remove fuel line at carb to see if fuel is ...

...fuel cap. ja The 2.0 CID is Cubic Inch Displacement, the size of your motor. As for fuel mixture, generally a 50:1 is a benchmark for this. Typically, it should be 1 gal. of gas for 2.56 oz. of two ...

...fuel cap fuel stopped coming in. Could I have a fuel or air circuit plugged or could my needle not be at the right height? The fuel metering needle in the lower carburetor chamber may have a bad ...

...fuel cap it might be on there molded in the plastic,if not call your local service center and they will be glad to help! One more question how does one own a blower that mixes fuel and one does not ...

...fuel cap does that function. Check your fuel lines and where they penetrate the tank. Today's fuel will eat the fuel line over time and there is also dry rot. The fuel lines on these need to be ...

...fuel that leaks where I pour it in the chainsaw. I make sure the cap is on there secure and on there correctly. Is there a gasket or something or a new cap? Model 3516 depends on what saw it is. some ...

...fuel cap. (empty all fuel from tank) then use a small gauge wire to fish out the end with the filter in the tank. attach a small piece of small gauge wire to the fuel line. then remove the old line ...