...Crown Vic: The crankshaft sensor and the DPFE(?) sensor; the main cause of the missing, cutting out, etc., however, was due to the fact that the #8 coil had gone bad and was fouling the spark plug. I ...
...fuel. 1999 Ford Crown Vicany ideas? first do you hear your fuel pump running? if you don't more then likely the relay may have went bad. second check your connection to your coil's..make sure there ...
...crown vic.police package, It bogs down when you give it gas but idles smooth,if you barely touch the gas it revs up fine. also we replaced the throttle position sensor and the pressure control switch ...
...crown vic takes off fine . It goes from 0 - 40 without any problems . after i reach inbetween 30 and 50 miles a hour the car starts to sputter . When i accelerate it doesent take off with full power ...
...crown vic 4.6 and i am having a problem getting spark from the spark plugs. i have checked all the fuses and relays no messed up wires or anything. the check engine light is on and stays on even when ...
...crown vic hit a bump and died. It will turn over, but it won't start up. I just decided to leave it by the road and come back at sunrise to figure out the problem. I would check the plugs around and ...
...crown vic 5.0 EFI will not start. Has working fuel pump and will run with starting fluid but will not start. What is the problem? there is definately a fuel problem, not getting to engine. check fuel ...
...crown vic wont start runs good when pouring gas in the carb but stalls out there is gas getting to the throttle body? and the return line but isnt coming out the injectors IF THE PROBLEM IS NOT THE ...
Question about 2000 Crown Victoria
...crown vic police intercepter the car will start but it dies in seconds i changed the fuel filter still same problem can someone please help me solve this problem? Have a repair shop check for failed ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
