Questions & Answers for: Jeep Grand Cherokee gauge problems

jumpy oil gauge 2000 Jeep Grand Cherokee When accelerating, oil gauge is normal, when idling, the oil gauge drops down to pegged. The oil has just been changed and is not leaking or low. Thanks OIL ...

The oil pressure gauge keeps dropping down to 0 while i am driving The oil pressure gauge keeps dropping down to 0 while the car is on. If you don't hear any ticking or knocking while the pressure ...

...problems with my gauges on a 2005 jeep grand cherokee laredo. The lights will flash on and off for all the functions such as low gas, tow haul mode, the fuel gauge, speedometer, rpm guage, and temp ...

...gauge at a parts store. Or you can have your mechanic do this for you it's not that big a job. BUT if the engine is clattering have it towed to the shop, you may have oil pump problems. Hope this ...

Temperature gauge redlines and check gauge light comes one only after driving 35 miles or so.I already replaced termostat and did a coolant flush. Water pump is not leaking no leaks any were. I am ...

check gages on jeep grand cherokee If your "Check Gauges" light is on, the light means pretty much whay it says...CHECK GAUGES! One or more of your gauges is/are reading outside of normal operating ...

Sometimes while driving, my fuel gauge is all over the place. It registers EMPTY when I just filled the tank at times. Today I just changed the fuel pump and sending unit, and the problem still occurs

My oil pressure gauge (on the top right of the dashboard) randomly shows the oil pressure going down to zero (check gauge light comes on) and then randomly goes back into the normal range. It happens ...

my check gauges light is on, oil hands goes over to zero, moves up, light goes off, when it drops back to zero, gauge light comes back on. trying to figure why the gauge for the oil hands going all ...

...gauge at 0, vehicle wont start. Could be connected, but could also be two different problems. It could be something in the key switch, or a wiring problem. Or it could be a wiring problem with the ...