I CANNOT FIND THE CAM POSITION SENSOR ON MY MOTOR if you have a chevy v8 up to 1998 (gen I/II) there is no cam sensor.
...lines and use hose clamps and rubber fuel lines to put it back together . It wont work on a 4th gen unless you cut a huge hole . Its a total barefoot redneck way to do it . Ive changed 4 in my
Engine light stays on steady P0102 Mass air flow remove maf and chech for debri on wires genly blow off wires and check air filter
I have a onan genset generator model #3.0AJ 1R/16017S serial # L830689411. It is wired wrond to my motor home it runs good but no electricity coming from generator to motor home, which is a 1982 ...
ran generator out of gas. added gas but no flow to gen. connected small squeeze bottle to line where it breaks gen ran fine. so fuel pump on gen is fine. respond to [email protected] If you ...
What does the fuse Gen Sensor (2.2L Engine) do in What does the fuse Gen Voltage Sensor (2.2L Engine) do in a car? the alternator wont charche
...and is the top must come off and most trucks have no huge floor pan plate to do that. some guys gen one up from scratch. G360? ...
Question about 1970 CHEVROLET MONTE CARLO Sales Brochure Book
GEN light on in a 1970 chevy monte carlo will start sometimes and had the voltage regulator replaced and still doing this?? voltage regulator was replaced, car starts when it wants to, and the GEN ...
Question about 1970 CHEVROLET MONTE CARLO Sales Brochure Book
Will rear seat from a 7th gen monte carlo fit a 1st gen monte carlo no they dont fit
Question about 2002 Suburban
...but it made a pop and does nothing? ??????? even flex fuel 5.3 L (325 cu in) Vortec 5300 LM7 V8 (Gen III) (1500 only) 5.3 L (325 cu in) Vortec 5300 L59 flex fuel V8 (Gen III) (1500 only)
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions