Questions & Answers for: Chevrolet Tahoe gm recalls ignition switch

...GM ignition switches are designed to be removed with the key in the on position. The lock tumblers in the old switch are likely stuck and/or worn, and if your key itself is worn that makes it worse. ...

...switch is bad. Alot of GM products have had this problem and alot of them have recalls take it to a dealer and ask if yours has a recall for this even if it is out of warranty some recalls ...

...ignition it started with Gm cars and trucks from 1999 to to 2006. It is a big problem but there is no recall that I know of. If that dont work a dealer needs to probably replace and reprogram your ...

...Repair shop should be able to get a new one or DORMAN PRODUCTS makes replacement clusters for most GM trucks. Gm did a recall on the the whole speedo

my rpm and speed gage stop working Typical GM. Your SPEEDOMETER, and Tach, quit working ? Go to ebay, find a guy from Winona, MN. he works on instrument clusters, he will fix ya right up. There was ...

...switch to different languages and will not reset to english GM products around that time had defective instrument clusters, you can find an aftermarket refurbished unit a lot cheaper than the dealer ...

...gm which has had many complaints but never has been recalled. Place key in ignition, turn to  ON Position. (do not start). Leave in ON position for Exactly 10 minutes. The light will shut ...

...any where on the panel. changed fuses and relay switch with same result. any ideas as to what the problem may be? GM has a recall on the blower cucirut for burn wires and the switch being

...gm-security.com/ Perform the re-learning procedure Turn ON the ignition, with the engine OFF. Attempt to start the engine, then release the key to ON (vehicle will not start). Observe the SECURITY ...

...I'm driving it. run the fault codes first could be a problem ignition switch ( gm products have a mass recall for vehicles up ti 12 years old) could be problem crank/ cam position sensors or ...