...shaft. If you take out the drain pump and spin the vane in either direction, you should feel a resistance every time you turn it. If you able to turn the vane one way and do not feel the resistance ...
...half. Hit the shaft with a mallet while supporting the back half off the floor so basket was free. I do not have a press that will take 30" diameter x 12" deep + another 8" for SS drum to hang into. ...
...shaft You can try a puller but typically it is recommended to replace the entire rear outer tub half (which comes with the bearings already pressed into it). You will also need the tub seal that goes ...
shaft i am unable to just pull rotor off as explained, therefore, how the hell do i get the rotor off, please Try putting the bolt about half way back in and hitting the head of the bolt with a hammer
...half of the tub shell assembly. Normally need to replace the inner basket/shaft assembly and the outer shell with the tub bearing. Sometimes the inner basket support will crack, ...
...pedestal. Half way attempted to take it off the pedistal and see if it is any better. 9 outa 10 times you will have a counter balance on the motor or shaft,this may be loose or missing hope this ...
...half of the outer wash drum (which contains the rear bearing and tub shaft seal) needs to be replaced. On a 1 - 10 scale, this rates a difficulty rating of about an 8. An experienced appliance tech ...
...half of the outer wash drum (which contains the rear bearing and tub shaft seal) needs to be replaced. On a 1 - 10 scale, this rates a difficulty rating of about an 8. An experienced appliance tech ...
Question about WM-1832C Front Load Washer
...If not, I would support the outer tub half on two saw horses or equivalent and hit shaft as hard as you can with a rubber mallet. Remember to have a system to catch the inner tub when it falls
Question about WM-2277HW Front Load Washer
...half way through wash did not spin hard and blew the circuit...motor smells hot The motors might be freezing they do get jammed with **** after time pull the motor to see if it's spinning if not look ...
Usually answered in minutes!
1,845 Questions
401 Questions
404 Questions
243 Questions
245 Questions