...hand brake not functioning properly the hand brake is very loose when applied,it dosent work properly on a slope either the hand brake needs to be adjusted or the rear brake shoes , which are inside ...
hand brake not active either the hand brake needs to be adjusted or the rear brake shoes , which are inside the rear discs are worn not allowing the hand brake to work
Question about Harley-Davidson Motorcycle Desktop Telephone
hand brake light then it would most likely be the brake nipple in the hand switch. but you did not say so I assume no brakes foot or hand. It could be on and you don't know it. Try removing one of the
Question about Harley-Davidson Motorcycle Desktop Telephone
brake hand brake locks it up tight. Know how you feel I've been there! Although your friend can't turn it dosent meen you have a good brake. so its not the reason it is jacked up that you have a brake
...hand brake adjustment We have replaced all the bake pads on a 1997 Levin BZR , We no have very poor hand brake performance. When we removed the rear bake pades we found that on caliper slider was ...
...the dash carefully. These is not too much room under there. Just ran you hand along the brake paddle. Press the brake switch by hand and see is brake light go on. Check all connectors for
...Hand Brake of Opel /vaxhaul/holden Zafira2002 The hand Brake cable was removed at the time of Repair of Brake Disk plate and replace of Brake Disk after re fixing of Cable the hand Brake Do not work, ...
Question about 2004 Optima
...hand brake light not working vp commodore.bulb has been replaced but still no go I assume the left hand brake light works. First check that you have replaced it with the correct bulb. Make sure it is ...
...hand brake adjustments. One is at the hand brake lever. open up the hand brake cover and look for the nut adjuster where the end of the hand brake cable is attached to. Tighten up that nut until you ...
hand brake not working As the title says. Replaced the rotors and brakes with great difficulty and now the hand brake doesnt work at all. Its tight on the hand brake lever. The hand brake cable by the
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions