Questions & Answers for: Harley Davidson handle release

...release of hand lever spray lithium grease on switch button and make sure housing for throttle and switches are as tight to brake handle clamp as possible. Also if there is the mechanical lever in ...

...I fit a throttle grip to my 2010 fatbob fxdx. thanks. First remove the switch cover just under the handle bars there are two rubber covered adjustment screws, roll back the rubber covers. mark where ...

...handle pulled. As soon as I put it in gear and release clutch It starts grinding. Fluid is at correct level. Any ideas Have you adjusted the clutch and cable since u had it. Make sure it is all ...

...handle is pulled Check to see if the clutch cable is broken. Watch the long clutch release lever under the oil tank as you squeeze the clutch lever. If it doesn't move when you squeeze the lever, ...

release after putting new brake lever on had to fix brake light on front brakes...ended up replacing brake lever, now brake pads are stuck... above it said select year...it didn't have my year

handle bars. Release tension on throttle cable by loosening cable adjusters. Release cable from carburetor. Release cable from throttle housing on handle bar. Reverse instruction to install new cables

...release the cable from the handle and do not drop any of these parts and then put the new lever on, reinstall the parts in the reverse order and adjust the cable so there is 1/16 to 1/8 inch freeplay ...

small srew on inside of bracket thru the release handle. do i need a certain tool, i cant get nothin between the fender and bracket. Hi Anonymous, call your local dealers service department. Good luck

handle bar lock will not release Hi Anonymous try pulling on the left handlebar hard while unlocking the lock. Good luck

...is fine. Lubed the cable. Lubed the clutch handle itself. Still too hard to pull. How did you check the cable???? Check the release mechanism on the ride side of the transmission, balls and ramp