...good. Check your connections. Your ground may have come loose. Your bulbs could be bad. Harleys tend to vibrate alot It is very common for them to shake loose a connection. Your rear
Harley they ever built and you may have some bulbs with broken filaments in them. Sometimes when a filament breaks rather than burns, the filament will make contact and the bulb works but when you hit
Question about 2005 FLSTN- FLSTNI Softail Deluxe
Brake lights wont work with hand or foot pedal. Tail lights work fine most likely the filament blew, change the bulb, there are two filaments in the bulb, one for tail light and one for brake.
Question about 2000 FLHTCUI Electra Glide Ultra Classic
my brake light does not work with neither front or back brakes on my electraglide but, my taillight does. The bulb has two filaments in the bulb. One filament is for the brake light and the other is ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
2007 electraglide standard brake light works but running light does not. This is a 2 filament bulb. The running light filament is probably broken. Pull the bulb and look at it. There should be a large
Backlight does not stay on at night.It is working only when you start/turn off engine for a short time Check the bulb for a broken filament. I've seen these filaments break and only make contact ...
Question about 2005 XL 1200 C Sportster Custom
84 harley sportster want to change from turn signal only ( one wire,black) to turn signal and marker light (two wire,purple and black) rear You'll have to replace the single filament turn signal ...
Question about 2007 FLHTCU Ultra Classic Electra Gilde
...Harley ultra Classic Hi Mike, always check the bulbs first for broken filaments. Then check the connection at the rear fender wiring harness, inspect for corroded, broken or loose pins. Use a dab of ...
...harley brake light doesn't not work with foot pedal or hand brake Hi Anonymous, always check the bulbs first for broken filaments. Then check the connection at the rear fender wiring harness, ...
...filaments. Then check the connection at the rear fender wiring harness, inspect for corroded, broken or loose pins. Use a dab of dielectric grease and repair as necessary. Check your brake relay if ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions