...head open"...we have reinstalled the ribbon and paper, cleaned the paper path and laser eye, but still getting "head open error" when the lever is definitely down in the correct position. If you open ...
Question about 170Xi II Thermal Printer
...at power up or after the print head is open & closed. I would select Power up since when you change lables out you should do so with printer off. Good luck, post any questions to this & also rate
Question about Thermal S4m Dt Zpl 203dpi Rs232/par & Usb Label Printer
...HEAD OPEN, ALERT RIBBON OUT Alert Head Open will show everytime u open the Head , when u close back the head it will show Alert CLeared Head Open, then it's normal. Ribbon Out Show means the printer ...
Question about 105Se Thermal Printer
...Head Open on Zebra printer model: Z90-401-00204 We have play around the pressure but still the same. What would be the root cause? Mechanical or electronic board or sensor. If the Head Open condition ...
Question about Z6M Plus Thermal Label Printer
...head open on Zebra 6m plus. Load ribbon and stock close head and it will start to calibrate then the error print head open comes up. 2 new sensors have been installed by a Peak tech. Is there any way ...
Question about 105SL Thermal Label Printer
Head is open" but Our Zebra 105SL is saying the "Head is open" but it isn't any thoughts on what to do? Open the side cover and to the top right is a sensor for the printhead, open and close
...Head open' doesn't disappear anymore until I switch the power off and on. Please try to open the head full until it has contact with the magnet on the inner side of the housing, than close ...
...printer and open and close the print head and the error is cleared. Then unpause the printer and does the same thing. Anyone any ideas? Thanks sensor not working or dirty in the feed path id ...
Question about ZM400 Thermal Label Printer - ZM400-3001-3000T
head is open, you will see 3 screw on the left, louse them and adjust all the print head mechanism, up and down some milliliters tie the screws again, close the printhead , try again and see if errors
Question about ZM400 Thermal Label Printer - ZM400-3001-3000T
...HEAD OPEN this printer is no longer supported by zebra. i could not find a service or parts manual but i can say there is a switch inside it that is made when you close the head. you can probably ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions