Questions & Answers for: no heat 2005 gmc sierra

Question about 2005 Sierra

2 Answers

2005 GMC Sierra battery went almost dead. Jumped it off and diver side air blows heat while passenger blow cold. Dual Controlled air. I pulled the positive cable for about five minutes and the problem

Ad

...2005 gmc sierra 2500hd.Heated seat turns off on drivers side after a few seconds .If the passenger has there seat on it will turn theres off too.Also the the heater turns off by itself once in ...

Ad

...2005 GMC Sierra 1500 4.8l 55k miles. Blower works in all heat settings, just no hot/warm air. Driver and passenger sides are the same. Feel little to no difference when moving the temp sliders from ...

...2005 GMC Sierra in order to install the seat heating element? take a pair of needle noe pliers and spread the hog rings out till they come off one at a time all the way around the bottom of the ...

...heat going in 2005 GMC sierra pickup. thermo goes to 210 as normal and no overheating. is there a temp sensor with electronic controls?? once heat comes on , varying hot/cold air blows?? stuck ...

...2005 gmc sierra truck is over heating and blowing hot then cold air. I can keep it from over heating if i turn my heater fan on high. If air is hot then cold it sounds like you have a sizable air ...

Question about 2005 Sierra 2500HD 4WD

1 Answer

...2005 GMC 2500 sierra, causing the transmission to heat up? This happens when pulling. the torque converter isnt locking up, if it doesnt lock then it just spins causing the transmission to slip and ...

Question about 2005 Sierra

1 Answer

...2005 gmc sierra with heated leather. my heated seats quit working. when i turn them on they light up like normal but they shut off in about 30 seconds. checked all fuses and they are fine. any ideas? ...

2005 gmc when the heat is on the blower works but no heat at bottom how do i remove the heater door motor You must remove the dash from the tuck. You will absolutely need the factory service manual to

2005 GMC Sierra 1500 6 Failure Date: 07/18/2009 The connector that plugs into the blower motor under the glove box became too hot and melted the plastic resulting in the a/c and heat not to work (this

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...