...heaterAC there is a loud humming noise that comes out of it kinda like the bearings in the blower motor are bad but its brand new. Any suggestions? MUST OF THE TIME THERE ARE LEAVES OR OTHER THINGS ...
...the actuator. Rotate the mode door linkage down. Rotate the actuator (2) so that the actuator linkage slips off the post on the mode door linkage.Remove the actuator linkage from the mode door ...
mode door linkage down. Rotate the actuator (2) so that the actuator linkage slips off the post on the mode door linkage.Remove the actuator linkage from the mode door linkage.Remove the IP extension.
mode door operation DESCRIPTION The mode door actuators are reversible, 12-volt direct current (DC) servo motors. The heating-A/C systems on this vehicle use two mode door actuators. One for the panel
Question about 2011 Liberty
...mode door actuators (1) to control the movement of the mode-air doors within the HVAC housing. When vacuum is supplied by the A/C-heater control to the vacuum connector (3) on one side of the ...
Question about 2003 TrailBlazer
mode and defrost door actuators. When the mode switch is placed in the defrost or defog positions the A/C is commanded on and the recirculation door is moved to the outside air position to help reduce
...mode door ? Temperature Blend Door Actuator - LH Removal and Installation NOTE: It is not required to install the new LH temperature blend door linkage parts included in the LH temperature blend door ...
Question about 2009 MKS
...mode door actuator through the mode door control circuit. Zero volts drives the actuator in one direction while 5-volts moves the actuator in the opposite direction. When the actuator receives 2.5 ...
...Mode" door actuator or a stuck mode door. That door is responsible for directing where the air comes out. Locate the mode door and disconnect the actuator. Move the door by hand. If it moves freely, ...
Question about 2009 MKS
...Mode door actuator feedback failure (bad servo) 32: Blend door actuator stall failure (stuck door or bad servo) 33: Mode door actuator stall failure (stuck door or bad servo) The actual problem is ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions