Questions & Answers for: Crosley heating vents

CDE6500W Not Heating I'm not sure if my heating element is bad or one of the fuses is bad. Can I tell if the heating element is bad without buying anything or having a service guy come out? It appears

...interior cools, then the thermostat tells the timer to stop advancing, and tells the dryer to start heating again. * This cycle continues until the clothes are dry. If the vent system is clogged, the ...

Crosley CDE6500AZW heating, but drum not rolling The problem happened after an indoor flap to the outside was installed backwards, preventing the air to vent out. One cycle was done like this. After ...

...circuit again and the heat can come on. Test the centrifugal switch Test the timer motor Test the heating elementGood luck !!! Regards ...

will not heat does not get hot will not heat unplu the dryer, take the vent off the vent tube, take out the metal tubes holding the back cover and tae off,inside you will see an oval shaped tube with ...

...the dryer, Tim: http://www.partselect.com/dryer+open-cabinet+repair.htm here is another website for heating problems and causes: http://www.partselect.com/dryer+dryer-wont-heat+repair.htm the most ...

...heating element is working on high heat and clothes are tumbling but after several cycles the clothes aren't dry. The lint trap has been cleaned out. Suggestions? the ducting is clogged or at least ...

The heating element is cycling in and out it will not stay on. The clothes takes two to three cycles to dry. What would make the heating element cycling in and out like this? Clean the exhaust vent ...

my dryer will heat high for a minute then hardly no heat IF IT HAS SOME HEAT BUT TAKES A LONG TIME TO DRY THEN YOU NEED TO CLEAN UR VENTING OUT THE TUBE THAT GOES FROM BEHIND DRYER TO THE OUTSIDE OF ...

why does my dryer have no heat and keeps running when i use the timed heat-sensing selection? I went to the wash room one morning to get the load of laundry i had thrown in the night before and to my ...