Questions & Answers for: Kenmore heating vents

...KENMORE DRYER IS NOT DRYING CLOTHES. IF YOU TURN IT ON, IT RUNS UNTIL YOU TURN IT OFF. IS IT THE HEATING ELEMENT? Run the dryer for a minute, then open the door and check for heat. If there is

dryer heats up and then cools off, won't stay hot. sounds like either the heating element or limit switches are going out on you Remove the vent from the rear of the dryer. With no laundry in the ...

Water in the vent hose ? And not heating fast or normal. When preparing to check out the dryer, upon pulling it out from wall, water was coming ( assume) from the vent at the dryer outlet, the vent ...

...pipe kinked not letting heat away from dryer, check vent , or the thermostt stuck and not cycling heating element cycle ...

...not dry as well low heat and then the heat goes away on any setting Your dryer may have a failed heating element (if electric), or a dirty burner (if gas). Likely though, the ducting that connects ...

my kenmore dryer will not heat up and timer will not shut off on auto `check ur restricted vent, or bad coils, is the vent is restricted the heat would built , but won't exit the machine, the gas ...

...kinks in the vent hose, lint build-up, etc. If you have a vent restriction, it causes the heating element or burner to over heat and shut down prematurely which extends the dry time ...

...heating. Will run but no heat. This happened once before and I thoroughly cleaned out all the vents, etc and it began to heat. The very next use, no heat again. What could it be. I will check the ...

Kenmore elite model 11062952100 My dryer will not heat I replaced The thermal cutoff and high limit thermostat the dryer produce heat briefly but is not producing heat again. There is a high limit ...

...electric dryer does not heat vent is clean but not heat up to dry clothes. You need to replace the heating coil that is usually the problem when you get air and and the tumbler is moving but no ...