Questions & Answers for: high idle ATVs

Question about 2004 FourTrax Foreman ES

2 Answers

...high idle or has to be tuned down so low that if it avoids the idle the motor dies. The carb is clean. Fuel diaphragam aged but undamaged, the manifold boot is uncracked with a new gasket. Starter ...

Ad

Question about 125cc Full Size Adult Quad ATV

1 Answer

...idle to high for the clutch to disengage while at idle? you might try to reduce the idle speed by turning eather the nob on carburator or the ajustement on the cable. then if the idle is very low and ...

Ad

Question about Quads 125cc Full Size Adult 4 Wheelers ATV

2 Answers

High Idle when we get the 70cc ATV running Pilot jet may be t o small or your air screw isn't adjusted right try turning the air screw in all the way then turn out 1full turn test and adjust until it ...

Question about Quads 125cc Full Size Adult 4 Wheelers ATV

1 Answer

...high idle and idle screw no help Have a 2007 artic cat atv 400 4by 4 automatic, Has continuous high idle and idle screw doesn't help. These atvs wont shift properly at high idle and so this is a ...

...high idle/rpm. Re-adjust back to normal idle but then again after a few minutes of riding it starts idling high again. ? sounds like an air leak in the intake system somewhere. clean the carb, check ...

sportsman 550 efi drives all the time when gears engagedeven on idle Adjust your engine idle its idling to high.

...idles very high @ wont slow down.all normal things look ok.idle adj. screw has no effect. is there a governor adj. ? Check got a air leak between carb. And eng. that will make it run lean and high ...

...on a 450 kodiak it started to idle to high and can't select gears probably not an idle problem but a failing throttle cable jamming in the outer case and not letting the system back to idle ...

...the idle screw, etc. Ideas? Adjust idle and mixture screws to default positions - start it and then make the necessary adjustments. Idle speed, low and high speed mixture settings if

...in gear the drivetrain holds it back or loads it down a bit. If you take off a load the idle will rise. Sounds like your idle is too high. Do you have your idle set high to keep it from

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...