Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...high idle..will cut for a few momments and then shuts down. The saw cuts out when I release the high idel trigger..It should just go into idle mode right? I played with the idle screw..got the chain ...
...idle and high idle? screw in lightly till seated then back out 1 turn each. low is for idling and turn in or out for best idle then run full throttle and do the same for it, get highest rpm then turn ...
...Idle to High Speed. The High speed adjustment screw is the one marked as "H" and would be adjusted during: 1. High speed or Wide Open Throttle. Turn about 1/8 either way to gain top RPM's and then ...
...high idle may also be out of adjustment, so tune this screw with the throttle on high (and running) until you hear the transition between the high rumbling sound and the high even sound this point is ...
...idle mixture screw, it might be the high speed mixture screw but is capped so it can't be adjusted. The low and high speed mixture screws should be marked next to each screw H and L. The 1 1/2 turns ...
Question about 30cc 17" String Trimmer Zrry30530 Wcurve Shaft
...#39;t reach top end speed. have a look on side of carby should see 3 small screws a high and a low idle screw , when running unsrew the high idle srew slightly and it should ...
Question about 30cc 17" String Trimmer Zrry30530 Wcurve Shaft
idle. If it's a high mix screw, its only effect will be at full engine speed. If the engine sounds throaty, turn that screw in 1/4 turn at a time at full engine speed At some magical point, the engine
...idle screw. Then gun unit at high speed and turn high screw for maximum rpm. Go from idle to max and make sure there is a smooth transition. If not play a tad with the idle mixture screw till that is ...
Question about 30cc 17" String Trimmer Zrry30530 Wcurve Shaft
idle some more but not to point where it starts to run rough. Then rev the sucker to high speed and adjust the high mixture for max speed. You may have to make a slight adjustment on the high speed to
Question about 30cc 17" String Trimmer Zrry30530 Wcurve Shaft
...highest rpm. Then go from idle to high speed. If not smooth a small adjustment on the high speed screw is in order. Keep doing that until you get a nice smooth transition form low speed to high
Usually answered in minutes!
295 Questions
300 Questions
122 Questions
96 Questions
40 Questions