High idle speed when the engine is cold What could be causing high idle spped after starting the engine when the engine is cold. The high idle speed lasts until the engine warms up. I have also ...
...AT THE THROTTLE BODY GASKET.IF ITS LEAKING OR BROKEN IT WILL CAUSE HIGH IDLE SPEED.IF ALL LOOKS GOOD.SCAN IT.CHECK FOR IDLE SPEED CONTROL FAULT.IF IDLE SPEED CONTROL GO BAD IT CAUSES HIGH IDLE
...high idle screw where do I start for as how many turns out for each one. Thanks Randy Hello Randy. I can talk you through making adjustments to your Jiffy ice auger engine. 1. Read through the whole ...
Question about Mitsubishi MGE 4000 Generator ROU Recoil Starter-Voltage Regulation:AVR. Fr
high idle speed. When I push the auto idle it will not change the speed to normal. It idles at high speed all time. If you have anything plugged into the generator, consuming any electric, it will run
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...idle speed and the high operating speed turn the high speed and low speed mixture screws right in[gently]then out 2.5 turns.start it up,screw the idle screw up till it will idle,then adjust low speed ...
...high speed/idle adjustment screws properly Before you remove or try to adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw ...
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...degree screwdriver. This allows access to the high speed jet which is on the bottom of carb...Adjust idle screw till smooth idle is obtained. Adjust high speed while running to obtain the highest
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
high. The idle speed is controlled by the engine computer through the idle air control valve , there are no provisions for adjusting idle . If idle is to high or you just think it's high , you need to
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
idle some more but not to point where it starts to run rough. Then rev the sucker to high speed and adjust the high mixture for max speed. You may have to make a slight adjustment on the high speed to
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...highest rpm. Then go from idle to high speed. If not smooth a small adjustment on the high speed screw is in order. Keep doing that until you get a nice smooth transition form low speed to high
Usually answered in minutes!
4,158 Questions
3,703 Questions
3,301 Questions
3,214 Questions
3,114 Questions
