Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...high idle..will cut for a few momments and then shuts down. The saw cuts out when I release the high idel trigger..It should just go into idle mode right? I played with the idle screw..got the chain ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...Idle to High Speed. The High speed adjustment screw is the one marked as "H" and would be adjusted during: 1. High speed or Wide Open Throttle. Turn about 1/8 either way to gain top RPM's and then ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...idle mixture screw, it might be the high speed mixture screw but is capped so it can't be adjusted. The low and high speed mixture screws should be marked next to each screw H and L. The 1 1/2 turns ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...idle mixture screw and high speed needle adjusting screws. Be sure to write the number of turns down on a piece of paper so you will know how many turns from the seated position to open the jets when ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...idle mixture screw and high speed needle adjusting screws. Be sure to write the number of turns down on a piece of paper so you will know how many turns from the seated position to open the jets when ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...idle mixture screw and high speed needle adjusting screws. Be sure to write the number of turns down on a piece of paper so you will know how many turns from the seated position to open the jets when ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
idle. If it's a high mix screw, its only effect will be at full engine speed. If the engine sounds throaty, turn that screw in 1/4 turn at a time at full engine speed At some magical point, the engine
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...idle screw. Then gun unit at high speed and turn high screw for maximum rpm. Go from idle to max and make sure there is a smooth transition. If not play a tad with the idle mixture screw till that is ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
idle some more but not to point where it starts to run rough. Then rev the sucker to high speed and adjust the high mixture for max speed. You may have to make a slight adjustment on the high speed to
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...highest rpm. Then go from idle to high speed. If not smooth a small adjustment on the high speed screw is in order. Keep doing that until you get a nice smooth transition form low speed to high
Usually answered in minutes!
295 Questions
300 Questions
122 Questions
96 Questions
40 Questions