...high speed idle adjustment. While machine is running turn the screw in just a little at a time listening for the idle to go up. If it doesn't go up and it starts to bog then turn the screw out and ...
Question about Lawn Mower With Toro Power Tools
...IDLE GOES FROM HIGH TO LOW BUT THEN KIKS BACK TO HI AGAIN AND THE CYCLE REPEATS BUT I DO NOT HAVE TO BACK OFF IN ORDER TO GAIN THE SPEED. THANKS, GEORGE Sounds like the belt might possibly be ...
Question about Blowers Rake and Vac - Electric Blower/Vac - 51573
...idle and hi/low speed screws? The high speed mixture screw is initially set at 1 & 1/2 turns out. Then adjust it to give good acceleration and top speed, while not closing the screw more than you ...
high speed----every man I know has looked at it taken it apart--cleaned and NOTHING seems to work??? there doesn't seem to be anywhere to adjust the idle? kinda hard to tell without a model number
Question about 2-Cycle 25.4 cc Straight Shaft Gas Trimmer 51974
...idle mixture screw and high speed needle adjusting screws. Be sure to write the number of turns down on a piece of paper so you will know how many turns from the seated position to open the jets when ...
...idle too high on my toro 20107 lawn mower and damage the engine. Does it cause any damage to the mower to mow, knowing the idle speed is low? It cuts just fine. You could also have an overused spring ...
...idle speed to high and damage the engine. I have set the idle speed lower and it cuts just fine. Can I cause any damage to my mower using it with with a lower idle speed? I do not think this will ...
...idle throttlexpostion is to high thus the engine runs faster at idle turn the screw located on either the butterflyistelf so less screw threes is against the carb body this should start lowering the ...
Usually answered in minutes!
370 Questions
122 Questions
62 Questions
64 Questions