Questions & Answers for: high idle speed Electrical Supplies

...AT THE THROTTLE BODY GASKET.IF ITS LEAKING OR BROKEN IT WILL CAUSE HIGH IDLE SPEED.IF ALL LOOKS GOOD.SCAN IT.CHECK FOR IDLE SPEED CONTROL FAULT.IF IDLE SPEED CONTROL GO BAD IT CAUSES HIGH IDLE

high idle speed. When I push the auto idle it will not change the speed to normal. It idles at high speed all time. If you have anything plugged into the generator, consuming any electric, it will run

...idle speed and the high operating speed turn the high speed and low speed mixture screws right in[gently]then out 2.5 turns.start it up,screw the idle screw up till it will idle,then adjust low speed ...

...high speed/idle adjustment screws properly Before you remove or try to adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw ...

...degree screwdriver. This allows access to the high speed jet which is on the bottom of carb...Adjust idle screw till smooth idle is obtained. Adjust high speed while running to obtain the highest

high. The idle speed is controlled by the engine computer through the idle air control valve , there are no provisions for adjusting idle . If idle is to high or you just think it's high , you need to

idle some more but not to point where it starts to run rough. Then rev the sucker to high speed and adjust the high mixture for max speed. You may have to make a slight adjustment on the high speed to

...highest rpm. Then go from idle to high speed. If not smooth a small adjustment on the high speed screw is in order. Keep doing that until you get a nice smooth transition form low speed to high

...high idle speed tends to indicate a fault but if after a thorough inspection the idle is still incorrect adjustment should be carried out using dedicated diagnostic equipment. Is it too high, low o ...

...idle speed high enough that it runs well enough to get through the idle mix adjustment without dying, but not so high that the carb high speed is opened. So if its dying while adjusting low speed, ...