Questions & Answers for: high limit switch pitco

High Limit Switch High limit switch went out on deep fryer. Cannot find anybody that has part. The actual switch didn't have a manufacture listed on it just these numbers: E50023LR30247 The thermostat

...high-limit? Your best bet is to replace both even though the hi limit is a switch & made to be reset. Buy both & install the t-stat, keep the hi limit WHEN at the most inopertune time it ...

...high limit switch remove connections from hi-limit switch, and put an ohm-meter across connections then heat it with a match or heat source of that temp range,heat the face and watch your meter it ...

high limit. It under your thermostat and has a red reset button that you can push to reset it. Check the wires that come from it and make sure they do not have a broken place in them. If not, you will

...limit switch/ device on fryers acts as safety device. It cuts gas supply on burners when it is triggered by high oil temperature in case the temperature regulating device failed to avoid further ...

Pitco fryer heat up but then stops heating us it the limit.switches? check the high limit

high limit switch? Hi there. Hi limits can be bypassed by connecting jumper wire from common to normally close terminals but this should only be done for testing purposes, if proven defective you have

...high limit switch for a Pitco VF35-S Frialator The pilot flame goes out when the thermostat knob is moved from the off position to the desired temperature setting. Could this be caused by a faulty ...

...been working on and off - can't seem to find the red button high limit switch for resetting it. Can;t see any red buttons at all. Any thoughts> they are auto resetting they have fenwall devices ...

...high temperature limit switch has been tripped and needs resetting. On gas deep fryers, "HEAT FAILURE" may display if the pilot fails to light or if the pilot flame is too weak as detected by the ...