Questions & Answers for: hose under seat

Question about Kirby Vacuums

1 Answer

...but It finally hit that hidden switch just right. The hose attaches to where the bag goes, and it just wouldnt seat properly. I suppose there might be some wear there on the hose end that twists in

Ad

...hose. please do not forget to rate and comment about your experience with fixya today. Removal & InstallationDisconnect the negative battery cable. Partially drain the cooling system into a clean ...

Ad

hose into the toilet seat mounting holes in the bowl. If the hose is too large, snip a small segment out of it to make it into a "C" shape, just large enough that the cut ends touch when inserted into

hose in the front seat dashborad area. You have to remove the dashboard to straighten out the hose. Sounds like a air blend door problem If you have duel a/c system ( Front & Rear ) and good freon

Question about 1993 Suburban

1 Answer

...carb i cant get it to seat any ideas CARB???? THE HEATER HOSES USE ORINGS TO SEAL IF IT HAS SWOLLEN UP OR THE PLASTIC LOCKING TABS HAVE FAILED YOU WILL NOT BE ABLE TO SEAT THE HOSE IN THE

Question about 1981 GS 750 L

1 Answer

...hose clamps from front and back of carbs) next(reomove scew from very top font of air box,near metal cross bar behind fuel tank) then wiggle carbs to separate from rubber intakes,unhook trhottle ...

...hose for located under front seat? there is a air line disconnected under seat. I wanted to know what it is for? That hose gets connected to the battery vent, if you look at the battery on one of the ...

hose. Cant get it to seat properly at pump connection. Found out it is 03 hose. They look the same. Are they different or am I missing something? The manufacturers change the fitting size when the gas

...Hose Replacement - Pump to Endgate Removal Procedure Remove the left front seat. Refer to Bucket Seat Replacement in Seats. Remove the rear seat. Refer to Rear Seat Replacement in Seats. Remove the ...

...ring where the hose mounts. System flush needed? Also P/S systems are usually sealed with nylon o rings and are hard to seat properly, besure they were replaced and or seated correctly during

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Vacuums Experts

AskDyson
AskDyson

Level 3 Expert

2572 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Anonymous

Level 3 Expert

43501 Answers

Are you a Vacuums Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...