... there would be other symptoms. There are a couple more fuses in the center console box labeled IGN/HVAC and MDL, but I think these run the air flow mode and other HVAC functions. Your blower is ...
...HVAC functions seem to be working normally except for the blower air, the most likely cause is a faulty blower resistor assembly ( for manual a/c) or a faulty blower motor control processor( for ...
...HVAC blower speed control My 2005 Buick Rendezvous HVAC blower quits running when the speed settings are changed, mostly when going from max to a lower speed. I was told that the speed control was ...
...HVAC control. The automatic system uses a blower control processor instead of a resistor assembly. Your owners manual should list the location of the fuses. You may need a shop manual to troubleshoot ...
...buick rendevous. No blower function Changed blower motor and resistor behind Where do i go now ??? Hvac controls Does it have manual controls, or is it an electronic /digital ...
Remove the HVAC control ? You need to?
How do I get to HVAC control module? please The module is what you touch to turn the A/C, and heat on. The bezel in front of it just pops off. Then remove the screws to pull out the controller.
Question about 2006 Rendezvous
...HVAC climate control display isn't working. The fuse inside is good. Where do I check nesxt? the connector for the blower resistor got hot and melted. The dash display for the climate control isn't ...
Question about 2004 Rendezvous
...among other places, sends voltage to hvac control module. I looked up info for automatic hvac. Are there any applicable hvac trouble codes? At the moment, I can't rule out the blower motor
Question about 2005 Rendezvous
...redevou The 10A A/C CLUTCH FUSE is in the underhood fuse block. In addition, the 10A IGN 3 HVAC FUSE and the 10A IP MDL FUSE in the center console fuse block are applicable to the HVAC control
Usually answered in minutes!
1,091 Questions
757 Questions
597 Questions
481 Questions
276 Questions